Pentair SuperMax (single-speed)
A 1.1 THP single-speed pump that drops in where a Hayward Super Pump was.
1.10 THP · 115/208-230V · single-speed
What we repair on the Pentair SuperMax (single-speed)
An induction motor with a start capacitor. The capacitor, the seal and the bearings are the usual failures — all repairable on the spot when the part is on the truck.
- Hums but will not start — usually the start capacitor, sometimes a seized shaft
- Trips the breaker or overheats — motor windings, wiring, or a failing bearing
- Leaking at the shaft seal (water under the motor) — a new mechanical seal before the bearings rust
- Air in the basket and losing prime — lid o-ring, basket, drain plugs, suction-side unions
- Loud grinding or screeching — worn motor bearings
- Low flow — impeller clogged or worn, diffuser gasket, basket
- Cracked strainer housing, lid or basket
The facts, from Pentair
- Type
- Single-speed
- For
- In-ground pools
- Ratings
- 1.10 THP
- Voltage
- 115/208-230V
- Maximum flow
- — not stated by the manufacturer
- Controls
- None on the pump
- NEMA Premium efficient motor
- Drop-in replacement for the Hayward Super Pump
| Model number | What it is |
|---|---|
| 348191 | DOE-compliant single-speed TEFC |
If it is time to replace it
Repair first when it makes sense. When the housing is cracked, the motor is failing on an old single-speed, or the parts are no longer made, these are the pumps to look at:
Pentair IntelliFlo3 VSF
Pentair's current variable speed and flow pump: it holds a set flow rather than just a speed, and runs from the Pentair Pool app over Wi-Fi.
1.5 THP · 3.0 THP · 115/208-230V (1.5 THP) · 208-230V (3.0 THP)
Specs, repairs & install →Our suggestion: Pentair's current variable-speed pump nearest in rating — we size the real replacement to your pool and plumbing.
Pentair IntelliPro3 VSF
The Sta-Rite-branded twin of the IntelliFlo3 VSF — the same installation guide, the same app control.
1.5 THP · 3.0 THP · 115/208-230V (1.5 THP) · 208-230V (3.0 THP)
Specs, repairs & install →Our suggestion: Pentair's current variable-speed pump nearest in rating — we size the real replacement to your pool and plumbing.
Why a replacement pump is almost always variable-speed now
- Since July 19, 2021, new pool filter pumps have had to meet a federal Department of Energy efficiency standard. For the common in-ground size — a single-phase, self-priming pump of about 1.15 motor horsepower (0.711 hydraulic horsepower) or more — DOE says that standard would likely require a variable-speed motor. (10 CFR 431.465)
- Since September 29, 2025, new pool pump motors from 1.15 to 5 total horsepower must be variable-speed — including a motor sold on its own to replace a failed one. Once older stock is gone, a worn-out single-speed motor of that size is replaced with a variable-speed one, not another single-speed. (10 CFR 431.485)
- Smaller pool pump motors (0.5 to under 1.15 total horsepower) must be variable-speed when made on or after September 28, 2027; DOE has said it will not seek penalties on those small motors made before March 26, 2029. (DOE enforcement policy, April 2026)
- ENERGY STAR still certifies pool pumps; EPA says certified in-ground models use about 20% less energy than standard ones. (ENERGY STAR pool pumps)
Where these facts come from
Checked against Pentair's own pages on 2026-09-23. Manufacturers change their lineups — if something here no longer matches, the manufacturer's page is right and we will fix ours.