Sold todayVariable-speed
Pentair IntelliFlo VS+SVRS
An IntelliFlo with a built-in safety vacuum release system (SVRS), which stops the pump when it senses a suction blockage.
3.95 THP · 230V · variable-speed
What we repair on the Pentair IntelliFlo VS+SVRS
A permanent-magnet motor run by an electronic drive — no start capacitor to replace. When one fails we read the drive's own fault before touching a part.
- Drive or keypad showing a fault, or the display dark — diagnosed against the manufacturer's fault list
- Not answering the automation or app — communication wiring and settings
- Speeds and schedules set wrong — reprogrammed for this pool, so it runs slow and quiet most of the day
- Leaking at the shaft seal (water under the motor) — a new mechanical seal before the bearings rust
- Air in the basket and losing prime — lid o-ring, basket, drain plugs, suction-side unions
- Loud grinding or screeching — worn motor bearings
- Low flow — impeller clogged or worn, diffuser gasket, basket
- Cracked strainer housing, lid or basket
From Pentair's manual
- Drive 356910Z (kit 356911Z) per Pentair's parts catalog.
The facts, from Pentair
- Type
- Variable-speed
- For
- In-ground pools
- Ratings
- 3.95 THP
- Voltage
- 230V
- Maximum flow
- — not stated by the manufacturer
- Built for
- Safety vacuum release — for pools that need one
- Controls
- On-board keypad
- Pentair automation: IntelliTouch, EasyTouch, SunTouch, ScreenLogic
- Built-in Safety Vacuum Release System (ASME A112.19.17); it cannot be switched off
- Password lock-out and minimum/maximum speed limits
- Permanent-magnet motor
| Model number | What it is |
|---|---|
| 011057 | IntelliFlo VS+SVRS |
| 011017 | Earlier VS+SVRS |
Where these facts come from
Checked against Pentair's own pages on 2026-09-23. Manufacturers change their lineups — if something here no longer matches, the manufacturer's page is right and we will fix ours.