Sold todayVariable-speed
Jandy VS FloPro (115/230V)
Jandy's compact variable-speed pump, sized to replace a single-speed of up to 1.5 HP. It runs from a controller or automation, not on power alone.
1.30 THP · 1.65 THP · 1.85 THP · 115/230V, auto-sensing · variable-speed
What we repair on the Jandy VS FloPro (115/230V)
A permanent-magnet motor run by an electronic drive — no start capacitor to replace. When one fails we read the drive's own fault before touching a part.
- Drive or keypad showing a fault, or the display dark — diagnosed against the manufacturer's fault list
- Not answering the automation or app — communication wiring and settings
- Speeds and schedules set wrong — reprogrammed for this pool, so it runs slow and quiet most of the day
- Leaking at the shaft seal (water under the motor) — a new mechanical seal before the bearings rust
- Air in the basket and losing prime — lid o-ring, basket, drain plugs, suction-side unions
- Loud grinding or screeching — worn motor bearings
- Low flow — impeller clogged or worn, diffuser gasket, basket
- Cracked strainer housing, lid or basket
From Jandy's manual
- It will not run on power alone: it needs a SpeedSet, JEP-R, iQPUMP01 or automation.
- Motor and drive assemblies R0960000 (1.30), R0960100 (1.65), R0960200 (1.85).
- To clear a motor error: breaker off, wait at least five minutes, power back on.
The facts, from Jandy
- Type
- Variable-speed
- For
- In-ground pools
- Ratings
- 1.30 THP, 1.65 THP, 1.85 THP
- Voltage
- 115/230V, auto-sensing
- Maximum flow
- — not stated by the manufacturer
- Controls
- SpeedSet or SpeedSet Plus controller on the pump
- iQPUMP01 with the iAquaLink app
- Jandy AquaLink automation or a JEP-R controller
- Replaces single-speed pumps up to 1.5 HP (1.65 and 1.85 THP)
- Adjustable base fits Pentair and Hayward footprints without replumbing
- TEFC variable-speed (ECM) motor
| Model number | What it is |
|---|---|
| VSFHP130DV / DVS / DVSP | 1.30 THP; S = SpeedSet, SP = SpeedSet Plus fitted |
| VSFHP165DV / DVS / DVSP | 1.65 THP |
| VSFHP185DV / DVS / DVSP | 1.85 THP |
Where these facts come from
- Jandy — VS FloPro 1.65 HP
- Jandy — VS FloPro 1.85 HP
- Jandy — VS FloPro dual-voltage service aid
- Jandy — VS FloPro DV installation manual
Checked against Jandy's own pages on 2026-09-23. Manufacturers change their lineups — if something here no longer matches, the manufacturer's page is right and we will fix ours.