Skip to content
Sold todaySingle-speed

Hayward Super Pump (single-speed)

Hayward's classic single-speed. The small DOE-compliant sizes are still sold; the larger ones are no longer made.

0.85 THP · 1.10 THP · 208-230/115V · single-speed

What we repair on the Hayward Super Pump (single-speed)

An induction motor with a start capacitor. The capacitor, the seal and the bearings are the usual failures — all repairable on the spot when the part is on the truck.

  • Hums but will not start — usually the start capacitor, sometimes a seized shaft
  • Trips the breaker or overheats — motor windings, wiring, or a failing bearing
  • Leaking at the shaft seal (water under the motor) — a new mechanical seal before the bearings rust
  • Air in the basket and losing prime — lid o-ring, basket, drain plugs, suction-side unions
  • Loud grinding or screeching — worn motor bearings
  • Low flow — impeller clogged or worn, diffuser gasket, basket
  • Cracked strainer housing, lid or basket

From Hayward's manual

  • Shaft seal SPX1600Z2.
  • The motor has an automatic thermal overload protector.
  • Self-primes up to 10 feet; a two-speed primes on high only.

The facts, from Hayward

Type
Single-speed
For
In-ground pools
Ratings
0.85 THP, 1.10 THP
Voltage
208-230/115V
Maximum flow
— not stated by the manufacturer
Controls
  • None on the pump — wired to a timer, a switch or automation
  • 2-inch ports
  • Swing-away hand knobs
  • Base takes 48- and 56-frame motors
Model numberWhat it is
SP2605X7Super Pump, 0.85 THP
SP2607X10Super Pump, 1.10 THP
SP2607X102STwo-speed, 1.0 THP (no longer sold)

If it is time to replace it

Repair first when it makes sense. When the housing is cracked, the motor is failing on an old single-speed, or the parts are no longer made, these are the pumps to look at:

Why a replacement pump is almost always variable-speed now

  • Since July 19, 2021, new pool filter pumps have had to meet a federal Department of Energy efficiency standard. For the common in-ground size — a single-phase, self-priming pump of about 1.15 motor horsepower (0.711 hydraulic horsepower) or more — DOE says that standard would likely require a variable-speed motor. (10 CFR 431.465)
  • Since September 29, 2025, new pool pump motors from 1.15 to 5 total horsepower must be variable-speed — including a motor sold on its own to replace a failed one. Once older stock is gone, a worn-out single-speed motor of that size is replaced with a variable-speed one, not another single-speed. (10 CFR 431.485)
  • Smaller pool pump motors (0.5 to under 1.15 total horsepower) must be variable-speed when made on or after September 28, 2027; DOE has said it will not seek penalties on those small motors made before March 26, 2029. (DOE enforcement policy, April 2026)
  • ENERGY STAR still certifies pool pumps; EPA says certified in-ground models use about 20% less energy than standard ones. (ENERGY STAR pool pumps)

Where these facts come from

Checked against Hayward's own pages on 2026-09-23. Manufacturers change their lineups — if something here no longer matches, the manufacturer's page is right and we will fix ours.

← Every pump we repair · Hayward repair near me

Free PDF Guide

Get Our Local DFW Pool Maintenance Checklist

Stop guessing. Download the exact month-by-month checklist our certified technicians use to keep Texas pools crystal clear year-round.

Value: $49

Where should we send it?

We respect your privacy. No spam.

Retail Store

Visit Us Today

Stop by for free water testing, expert advice, and professional-grade supplies.

Simplified Pools

1611 Commons Cir Suite 100, Northlake, TX 76226
Northlake, TX 76226

Get Directions →
Call Now
Book Service