Sold todayVariable-speed
Hayward Super Pump VS 600 Series with OmniX
A drop-in variable-speed Super Pump for replacing a single-speed, run from the OmniX app.
1.65 THP · 2.25 THP · 115/230V · variable-speed
What we repair on the Hayward Super Pump VS 600 Series with OmniX
A permanent-magnet motor run by an electronic drive — no start capacitor to replace. When one fails we read the drive's own fault before touching a part.
- Drive or keypad showing a fault, or the display dark — diagnosed against the manufacturer's fault list
- Not answering the automation or app — communication wiring and settings
- Speeds and schedules set wrong — reprogrammed for this pool, so it runs slow and quiet most of the day
- Leaking at the shaft seal (water under the motor) — a new mechanical seal before the bearings rust
- Air in the basket and losing prime — lid o-ring, basket, drain plugs, suction-side unions
- Loud grinding or screeching — worn motor bearings
- Low flow — impeller clogged or worn, diffuser gasket, basket
- Cracked strainer housing, lid or basket
From Hayward's manual
- Same ring-light codes as the TriStar VS 800 (1 voltage, 2 current, 3 heat, 4 stalled, 5 drive, 6 module).
The facts, from Hayward
- Type
- Variable-speed
- For
- In-ground pools
- Ratings
- 1.65 THP, 2.25 THP
- Voltage
- 115/230V
- Maximum flow
- — not stated by the manufacturer
- Controls
- OmniX app over Bluetooth
- Optional OmniX Gateway
- 600–3450 RPM
- 2-inch female NPT ports
| Model number | What it is |
|---|---|
| VSP26615 | Super Pump VS 615, 1.65 THP |
| VSP26620 | Super Pump VS 620, 2.25 THP |
| W3VSP26615 / W3VSP26620 | Open Line versions |
Where these facts come from
- Hayward — Super Pump VS 620 with OmniX
- Hayward — Super Pump VS 600 Series sell sheet
- Hayward — VS pumps with OmniX manual
Checked against Hayward's own pages on 2026-09-23. Manufacturers change their lineups — if something here no longer matches, the manufacturer's page is right and we will fix ours.