Green Pool Recovery Kit
3-5 days to fully clearEverything you need to kill algae and restore crystal clear water. Follow the steps in order.
Step-by-Step Protocol
- 1Brush entire pool — walls, floor, steps, corners
- 2Add 3-4x normal shock dose (run pump 24/7)
- 3Wait 24-48 hours for chlorine to drop below 5 ppm
- 4Add algaecide per label directions
- 5Add clarifier to catch dead algae particles
- 6Clean filter every 8 hours until clear
Products for This Kit
Weekly Maintenance Bundle
Ongoing weekly routineKeep your pool balanced and sanitized week after week. The same chemicals our service techs use on every visit.
Step-by-Step Protocol
- 1Test water chemistry (FC, pH, TA)
- 2Add liquid chlorine or tabs to maintain 1-3 ppm FC
- 3Adjust pH with muriatic acid or soda ash if needed
- 4Shock weekly during swim season (1 lb per 10K gal)
- 5Add algaecide preventatively every 2 weeks
Products for This Kit
Spring Pool Opening Kit
2-3 days to swim-readyOpen your pool right after winter. Remove debris, shock heavily, and balance all chemistry levels.
Step-by-Step Protocol
- 1Remove cover, skim debris, brush walls
- 2Fill pool to proper level and prime pump
- 3Run pump 24 hours, then test water chemistry
- 4Triple-shock the pool (3 lbs per 10K gal)
- 5Balance pH (7.2-7.6) and alkalinity (80-120 ppm)
- 6Add stabilizer/conditioner if CYA is below 30 ppm
- 7Add algaecide after chlorine drops below 5 ppm
Products for This Kit
Winter Pool Closing Kit
Allow 1 full dayWinterize your pool to prevent algae, scale, and freeze damage over the off-season.
Step-by-Step Protocol
- 1Balance all water chemistry (pH 7.2-7.6, TA 80-120, CH 200-400)
- 2Super-shock the pool (3-4 lbs per 10K gal)
- 3Add winterizing algaecide (non-copper based)
- 4Add stain & scale preventer
- 5Lower water level below skimmer
- 6Blow out plumbing lines and add antifreeze if needed
- 7Cover pool securely
Products for This Kit
Chemical Safety & Dosage Accuracy
All dosage recommendations are based on NSPF/PHTA CPO Handbook standards and manufacturer Safety Data Sheets (SDS). Actual dosages may vary by product concentration, water temperature, and bather load. Always read the product label and SDS before use. SDS documents are available from each manufacturer or upon request from our team. Never mix chemicals directly. When in doubt, add less and re-test after 30 minutes of circulation. For professional dosing assistance, call (469) 455-1054.
Want us to handle the chemicals for you?
Our weekly pool service includes all chemicals, testing, and balancing. Starting at $165/month.